Installation
Installing Creekside Flooring is designed to be simple, secure, and stress-free. Whether you’re working with a contractor or handling it yourself, the steps below cover the most important things to know before, during, and after installation.
Before You Begin
- Check Your Materials
- Confirm you have the correct product, color, and quantity.
- Mix planks from multiple boxes to ensure natural variation.
- Defects must be reported before installation begins.
- Prep the Room
- Ensure the room temperature is between 60–85°F.
- Keep humidity between 35–65%.
- Subfloors must be clean, level, and dry.
- Floors can be installed over wood or concrete.
- Acclimation & Storage
- Acclimation isn’t required, but flooring should be at room temperature.
- Store planks flat and away from direct sunlight, heaters, or vents.
- Safe for use in 3-season rooms with temps up to 140°F.
The Uniclic Floating Floor
Our planks use the Uniclic® system — no glue required. You can install using two methods:
- Angle Click Method: Angle the plank at 20–30°, then push gently down to click into place.
- Flat Tap Method: Lay flat and use a tapping block to click planks together.
Installation Tips:
- Start with a full plank. Cut the tongue edge off the first row facing the wall.
- Use spacers to leave a ¼” expansion gap along all walls and fixed objects.
- Stagger seams at least 6 inches apart between rows.
- For rooms over 40 feet long or wide, use a ½” expansion joint.
Radiant Heat & Special Areas
- Radiant heat floors are allowed, but surface temps must not exceed 85°F.
- Gradually increase heat after install.
- Safe for 3-season rooms when proper conditions are met.
Trim & Stair Pieces
We offer a complete line of waterproof trim options to finish your project with a clean, professional look:
- End Cap: Fills gaps near carpets, sliding doors, or hearths.
- (For floors 2–6mm thick)
- Multi-Trim: Automatically adjusts for floors of different heights; works as a reducer.
- Stair Nose: Used to finish stair edges with a flush fit.
Installation Instructions
Final Steps & Finishing Touches
- Remove spacers and install baseboards or quarter-round (don’t fasten to the floor).
- Use rosettes or caulk around pipes.
- Clean up with a soft broom or vacuum (no beater bars).
- Avoid wet mopping for the first 5 days.
Need More Help?
Reach out to our team anytime — we’re here to help make your install smooth from start to finish.
